Sign up to the Tiling Logistic’s newsletter to stay informed about new products, offers and promotions
Aquaseal Wet Room Tanking System Large Kit 7.5 Metre Product Description The Aquaseal Wet Room System is designed to provide a permanently flexible watertight membrane prior to tiling in areas such as showers, wet rooms, wet zones in bathrooms and other tiled areas subject to water exposure such as balconies and partially covered external areas. The Aquaseal Wet Room System consists of a primer, tanking tape, tanking membrane and drain mat and is based on tried and tested wet room tanking principles used in areas such as Scandinavia and Germany where wet rooms have been common for many years. Benefits All components contained in 1 kit. Single components also available. Easy reference instructions on all components. Tested to BS/EN 14891 All products also sold separately should you run out no need to buy another full kit Areas for Use For showers, wet rooms and wet zones in bathrooms Use on all board joints, corners & pipe entries. Waterproofing prior to tiling. For use on plasterboard, MDF, concrete, wet room boards, plywood etc. ply lined wooden floors Limitations Do not use on timber or boards treated with spirit or stearate based coatings Do not use in areas subject to very high temperatures It is the user’s responsibility to determine suitability for use. If in doubt contact Technical Services for advice. Surface Preparation All surfaces must be clean sound and dust free. Application The Large Size kit Aquaseal Wet Room System is a Waterproof Tanking Kit that contains all you need to waterproof 7.5 square metres Products in each kit STEP 1 –WATERPROOF TANKING PRIMER A ready to use primer, applied by brush to all porous and semi porous surfaces in the areas that are to be waterproofed. It is quick drying and can be over coated after 1 hour. STEP 2 –WATERPROOF TANKING TAPE A self-adhesive joint & corner sealing butyl backed fleece tape that should be applied to all corner joints, board joints and pipe penetrations to provide a watertight seal that accommodates cross directional movement. The Large kit Contains a 10 metre roll which is usually sufficient to waterproof the corners in a 7.5 square metre application. STEP 3 –WATERPROOF DRAIN MAT Self-adhesive butyl backed fleece capable of coping with board movement around the drain outlet, which is the area most susceptible to water leaks. STEP 4 –WATERPROOF TANKING MEMBRANE A ready to use, liquid waterproofing compound which is applied in a 2 coat system by brush to provide a permanently flexible watertight membrane. Non-hazardous and solvent free. It is quick drying and tiling can commence after 24 hours. 5 litres in large kit. The tape can be over coated with Aquaseal Waterproof Tanking Membrane immediately after application. On internal corners ensure the tape overlaps on both sides to avoid a weak spot in the centre of the internal corner.