Faber Showroom Terracotta Impregnator Water Repellent Treatment for Cotto 1L

Faber Terracotta Impregnator is a water-based, water-repellent impregnating agent to provide deep-down, effective and completely invisible protection for cotto and terracotta against water absorption and rising dampness. Faber Terracotta Impregnator protects treated materials against all of the problems linked to water absorption or rising damp, such as marks, the appearance of salts and efflorescence, algae, moss, mould, disintegration and surface spalling. Faber Terracotta Impregnator is able to penetrate deep down into the material to provide surface protection, preventing water absorption as well as moisture from rising up through the material

Faber Terracotta Impregnator can be used as a grout release treatment if applied to cotto or terracotta before proceeding to wash and grout, effectively protecting the material against grout stains from final washing. Faber Terracotta Impregnator is completely invisible and will not change the appearance, tone or colour of the treated surface. Faber Terracotta Impregnator makes routine surface maintenance easier, limiting a surface’s ability to trap dirt which prevents it from penetrating below the surface and attaching to the material

Faber Terracotta Impregnator can also be used as a water-repellent primer before applying a stain-proofing product. Faber Terracotta Impregnator can be applied, after diluting it, quickly and easily. It is specifically for application on cotto and terracotta, but it can also be used on all particularly absorbent materials

Suitable For Use On:
- Cotto
- Terracotta
- Cement-Marble Agglomerate
- Concrete
- Cementine
- Tuff
- Porous Stones

Coverage (1 Litre):
- Approximately 10-15 squared metres, depending on the absorption level of the surface

Method Of Use:
- Dilute down with clean water in the ratio 1:2-3 parts water
- Thoroughly rinse the surface with clean water and allow it to dry
- Apply a thick, even layer of Faber Terracotta Impregnator on the surface using a clean brush, cloth, roller or spray
- Be sure to quickly even the layer across the whole surface
- Faber Terracotta Impregnator looks visibly dry a little time after application
- Before proceeding with any type of treatment, it is necessary to wait for it to be completely dry, which generally occurs about 24 hours after application
- If needed, apply a second coat about 1 hour after the first, following the same application process

Additional Information:
- Never apply Faber Terracotta Impregnator to wet or heated surfaces
- Any adjacent surfaces not being treated with Faber Terracotta Impregnator must be protected
- It is important to test the solution on an inconspicuous area before general application

The Faber Terracotta Impregnator is available through Tiling Logistics, the natural stone renovation specialists based in Birmingham. We strive for a same-day dispatch service and free delivery is available on orders over £75.