Facebook Pixel
LTP Tile and Stone Cleaning, Sealing and Maintenance

LTP Colour Intensifier

SALE From £9.36 £7.80 RRP £14.29
SALE From £9.36 £7.80 RRP £14.29
More Information

- Colour Enhancing Tile Sealer
- Performs Well in Wet Areas inc. Bathrooms/Wetrooms
- Allows The Surface To Breathe
- Interior & Exterior Use

Full Description

LTP Colour Intensifier and Stainblock is an impregnating sealer for natural stone, slate and other surfaces to give an enhanced matt finish. LTP Colour Intensifier and Stainblock is formulated to act as a resistance to strongly protect itself against water, oil grease and dirt.

LTP Colour Intensifier and Stainblock is used on wall and floor surfaces. Performs well in wet areas including bathrooms, wetrooms and swimming pool surrounds. Most suitable on floors that have no damp proof course. Maintained with LTP Waxwash on floors and LTP Stonewash on walls.

Suitable for Use On:
- Slate
- Natural Stone
- Tumbled Marble
- Travertine Marble
- Terracotta
- Quarry
- Terrazzo
- Sandstone

Coverage Guide :
- Lower porosity: 1-2 litres covers approx 10 square metres
- Higher porosity: 3-4 litres covers approx 10 square metres

Method of Use:
- The surface must be completely clean, dry and free from contamination
(If necessary, LTP Grimex is recommended to clean the floor and allow it to dry thoroughly)
- Apply LTP Colour Intensifier and Stainblock in thin coats with a cloth, brush, or sponge
- Leave for 15-30 minutes then wipe over with a dry, clean cloth to remove any excess
- Leave for a total of 30-60 minutes before applying a further coat
- The surface must retain a natural finish after treatment, with no excess remaining
- LTP Colour Intensifier and Stainblock will take two hours to dry but will take a further three days to become fully resistant

Additional Information:
- LTP Colour Intensifier And Stainblock is very difficult to remove once hardened, DO NOT OVER APPLY
- It is important to test the solution on an inconspicuous area before general application

- Do not apply in direct sunlight or in a temperature exceeding 25 ̊C
- Use only in well-ventilated areas
- Do not apply on floors with underfloor heating on as the product may dry prematurely
- Following application DO NOT allow surfaces to get wet and keep dry for a minimum of 3 days

The LTP Colour Intensifier and Stainblock impregnating sealer is available through Tiling Logistics, the natural stone renovation specialists based in Birmingham. We strive for a same-day dispatch service and free delivery is available on orders over £75.

Write Your Own Review
You're reviewing:LTP Colour Intensifier and Stainblock Impregnating Sealer
Your Rating
You may also like...