LTP Glaze Protector Low Maintenance Self Shine Sealer
- Low maintenance self shine sealer
- For interior use only
- Highly resistant to wear and stains
LTP Glaze Protector 1L is a low maintenance self shine film forming sealer for glazed ceramic and porcelain, unpolished porcelain and vitrified quarry tiles. Protects and embellishes the surface. Highly resistant to wear and stains. Facilitates maintenance and cleaning. Leaves surfaces with a ‘just washed’ look. Maintain with LTP Floorshine.
LTP Glaze Protector 1L INTERIOR USE ONLY
(Not wet rooms or shower enclosures)
Retains the ‘just washed’ look on glazed ceramic, porcelain, unpolished porcelain and vitrified quarry tiles. Easy to maintain.
LTP Glaze Protector 1L Application
Newly installed surfaces - ensure surface to be treated is completely clean, dry and free from cement and grout stain (see LTP Grout Stain Remover).
Existing surfaces - first clean and degrease surfaces with LTP Grimex and rinse well. Leave to dry out thoroughly (24 hrs). Any retained moisture in the grout joints may cause the LTP Glaze Protector to dry opaque or prevent the seal from reaching full hardness.
Apply using a J cloth or sealant applicator pad. Pour contents into a separate container. Dip cloth into the solution and wring out Apply evenly to the surface without rubbing. Apply until an evenly thin film is created (Avg. 3 times). Allow to dry (1 hr). For a glossier finish further coats should be applied at right angles to the first (max.6).
Do not over apply as too many coats may cause unsightly build up and/or reduce the efficiency of the product. Hardens after about an hour but will take a further three days to achieve full hardness and become fully water resistant. Always test first to establish the correct method of application and optimum number of coats before general use.
Avoid extremes of temperature. Do not apply on to rubber floors.
LTP Glaze Protector 1L Aftercare
Routinely sweep the floor. Use LTP Floorshine to clean and protect treated surfaces. In areas where the seal becomes worn, apply more LTP Glaze Protector. At some stage, complete renovation of the seal may be desired. In this case use LTP Grimex to strip the original seal before re-sealing. Avoid using strong detergents to wash surfaces treated with LTP Glaze Protector.