LTP Grout Stain Remover Cement Limescale and Grout Residue Remover for Interior and Exterior Use
• Also removes grout residue
• For interior & exterior use
• A rapid action cleaning agent
LTP Grout Stain Remover Cement Limescale and Grout Residue Remover for Interior and Exterior Use.
Cement, Limescale & Grout Residue Remover For Interior & Exterior use For glazed and un-glazed ceramics, slate, quarry tiles, brick, terracotta & acid resistant natural stones. A rapid action cleaning agent for removing cement residues, grout stain, efflorescence and other similar deposits from glazed and unglazed ceramics, slate, quarry tiles, brick, terracotta, and stone. May be used in dilute or concentrated form. (Do not use on Limestone, marble or other acid sensitive surfaces).
LTP Grout Stain Remover Cement Limescale and Grout Residue Remover for Interior and Exterior Use Approximately 5-25m2 per litre.
LTP Grout Stain Remover Cement Limescale and Grout Residue Remover for Interior and Exterior Use. Not suitable for use on surfaces that are calcareous, sensitive to acids (e.g. stainless steel, chrome, enamel etc), or contain lime (i.e. marble, travertine,limestone, engineered stone & sandstone containing iron). In conditions of extreme humidity LTP Grout Stain Remover vapour may react with acid sensitive surfaces. Any contaminated surface should be rinsed off immediately with plenty of clean water. Do not use when under floor heating systems are in operation. Important: - Always test the solution on a small inconspicuous area prior to general application. Work in manageable sized areas. Prolonged contact with grout joints should be avoided.
LTP Grout Stain Remover Cement Limescale and Grout Residue Remover for Interior and Exterior Use Application
In mild cases and on absorbent tiles:
Dilute 1 part Grout Stain Remover in 4 parts water. Apply with a cloth or sponge wrung out in the solution. Wipe off thoroughly with a clean damp cloth.
In more severe cases:
Dilute 1 part Grout Stain Remover in 1 part water. Apply liberally and spread over surface of tiles. If necessary, agitate with a scrubbing brush and leave to react for 5-10 minutes, keeping wet with additional Grout Stain Remover solution. Mop up and rinse thoroughly with clean water.
In extremely severe cases:
Use undiluted and agitate with scrubbing brush or mechanical scrubber if necessary. Neutralise treated surface with clean water after use.
- LTP Mattstone Natural Matt Finish Impregnating SealerSALE From £9.91 £8.26 RRP £15.72
- LTP Colour Intensifier and Stainblock Impregnating SealerSALE From £9.36 £7.80 RRP £14.29
- LTP MPG Polished Wall And Floor Tile SealerSALE From £11.00 £9.17 RRP £15.72
- LTP Mattstone H20 Water Based Impregnating SealerSALE From £21.84 £18.20 RRP £32.64