Facebook Pixel
LTP Ironwax Satin Self shine Satin Finish Sealer
LTP Ironwax Satin Self shine Satin Finish Sealer
LTP

LTP Ironwax Satin Self shine Satin Finish Sealer

SALE From £14.99 £12.49 RRP £18.00
SALE From £14.99 £12.49 RRP £18.00
More Information
Downloads
• Interior use only.
• Self-shine satin finish film forming acrylic sealer
• Suitable for Interior use only.
• Low maintenance.
• Protects against staining & dirt.
Full Description
LTP Ironwax Satin Self shine Satin Finish Sealer.

Coverage Approximately 15-30m2 per litre (one coat) depending on substrate porosity.

Suitable for Interior use only (Not wet rooms or shower enclosures)
For travertine, slate, limestone, sandstone, bricks, terracotta, unpolished marble, porous quarries, terrazzo and concrete.

LTP Ironwax Satin Self shine Satin Finish Sealer. Easy to apply, low maintenance self-shine satin finish film forming acrylic sealer. Enhances colour and texture, protects against staining and stubborn dirt, easy to maintain. May be used on travertine, limestone, sandstone, slate, un-polished marble, terracotta, porous quarries, bricks, terrazzo and concrete Suitable for domestic and commercial use. Maintain with LTP Floorshine.

LTP Ironwax Satin Self shine Satin Finish Sealer Application.
Ensure surface to be treated is completely clean, dry (min 24hrs). Any retained moisture may cause the LTP Ironwax Satin to dry opaque or prevent the seal from reaching full hardness. Pour contents into a separate container. Rough cut, textured or riven surfaces Use a sponge or paint brush, apply a thin coat evenly in one direction. Do not rub or buff. Allow to dry (1 hr). Apply until an evenly thin film is created. (Avg. 3 times). For a higher sheen further coats should be applied at right angles to the previous (max.6). Honed and smooth surfaces apply using a J cloth or sealant applicator pad. Apply a thin coat evenly to the surface without rubbing. Apply until an evenly thin film is created (avg. 3 times). Allow to dry (1 hr). For a higher sheen further coats should be applied at right angles to the first (max.6).
Do not over apply as too many coats may cause unsightly build up and/or reduce the efficiency of the product. Hardens after about an hour but will take a further three days to achieve full hardness and become fully water resistant.

LTP Ironwax Satin Self shine Satin Finish Sealer Aftercare.
Routinely sweep the floor. Use LTP Floorshine to clean and protect treated surfaces. In areas where the seal becomes worn, apply more LTP Ironwax Satin. At some stage, complete renovation of the seal may be desired. In this case use LTP Grimex to strip the original seal before re-sealing.
Write Your Own Review
You're reviewing:LTP Ironwax Satin Self shine Satin Finish Sealer
Your Rating
You may also like...
Trustpilot