LTP Mattstone Natural Matt Finish Impregnating Sealer
• Water, oil & grease repellant
• Allows surfaces to breathe.
• Minimal change to the natural appearance.
LTP Mattstone Natural Matt Finish Impregnating Sealer.
For interior & exterior use.
LTP Mattstone Natural Matt Finish Impregnating Sealer Suitable for all types of natural and artificial stone, unglazed porcelain, sandstone, slate, marble, terracotta, quarry, brick & concrete. A natural, matt finish impregnating sealer. Helps protect against staining. Strongly repels water, oil and grease. Allows surfaces to breathe.
LTP Mattstone Natural Matt Finish Impregnating Sealer Coverage
Lower porosity floors - approximately 1-2 litres
Higher porosity floors - approximately 3-4 litres
LTP Mattstone Natural Matt Finish Impregnating Sealer Aftercare
Routinely sweep the floor and wash with LTP Waxwash. Clean walls and work surfaces with LTP Stonewash Spray. Every 3 – 4 years surfaces may require more intensive cleaning in which case use LTP Grimex. Surfaces may require a top up coat of sealer after intensive cleaning. Refer to LTP Grimex technical data sheet for more information.
Shake the bottle prior to use. Ensure surface to be treated is completely clean and dry. Apply with a soft cloth, brush or sealant applicator pad allowing at least two hours between coats. More absorbent floors may require further coats and on such floors the product should be generously applied. After one hour rub over the surface with a soft fluff free cloth or buffing machine to obtain a uniform finish and remove any excess sealer. This product will dry after about two hours, but will take a further three days to become fully resistant. N.B. The aim is to completely fill the substrate with sealer without over applying it. Do not apply in direct sunlight. The sealer will help to inhibit oil based stains but such spillages should be wiped up immediately. On rougher surfaced floors it may be prudent to use an appropriate surface sealer as well . Some surfaces may appear delicately enhanced once dry. Use only in well ventilated areas. Do not breathe vapours. Do not use in temperatures under 5°C or over 25°C. FOLLOWING APPLICATION DO NOT ALLOW SURFACES TO GET WET AND KEEP DRY FOR A MINIMUM OF 3 DAYS. Always test first on an inconspicuous area, prior to general application.
- LTP Grimex Heavy Duty Grime And Stain RemoverSALE From £7.56 £6.30 RRP £11.33
- LTP Power Stripper High Performance Intensive CleanerSALE From £13.86 £11.55 RRP £19.76