LTP MPG Polished Wall And Floor Tile Sealer

LTP MPG Polished Wall And Floor Tile Sealer

Coverage Approximately 10 - 30 square metres/litre depending on surface porosity.

LTP MPG Polished Wall And Floor Tile Sealer. Impregnating sealer for polished porcelain, marble, limestone, slate & granite. Colourless and easy to apply impregnating sealer. Suitable for polished floors, walls, worktops and fireplaces. Does not alter the polished finish of the surface. For interior and exterior use. Maintain with LTP Waxwash for floors and LTP Stonewash for wall & worktops.

LTP MPG Polished Wall And Floor Tile Sealer Application
Surfaces should be completely clean and dry. If necessary use LTP Grimex .. NB: It is important to remove any factory applied sealer or wax from the tiles before sealing. Apply thinly and uniformly using a soft cloth, sealant applicator pad or sponge. Within 20 minutes, whilst the sealer is still wet on the surface, buff well using a clean dry cloth or buffing machine. Leave to dry for 4 hours and then on more porous surfaces apply a second coat using the same method. It is important to remember to remove any excess from the surface and buff well between each coat. Do not apply in temperatures exceeding 25°C. Ensure underfloor heating is switched off. Over applied sealer will dry leaving a greasy residue on the surface. To remove, apply white spirit or a little more sealer and then buff immediately. Always test on an inconspicuous area first. Treated areas should be dry enough to walk on after about 4 hours but will take 3 days to become fully resistant.

LTP MPG Polished Wall And Floor Tile Sealer Aftercare
Use LTP Porcelain Floor Tile Cleaner and LTP Stonewash for walls. For stubborn surface marks use LTP Grimex, in which case you may need to re-seal treated areas. Do not use strong bleach cleaners for routine aftercare.