We use cookies to ensure that we give you the best experience on our website. If you continue to use this site we will assume that you are happy with it. Learn more

LTP Grout Stain Remover - Cement, Limescale and Grout Residue Remover for Interior and Exterior Use
- LTP Grout Stain, Cement & Limescale Remover
- A Swift Action Cleaning Agent
- Grout Stain Remover: including Efflorescence
- Interior & Exterior use
- Dilute with water to a ratio of between 1:1 and 1:4
LTP Grout Stain Remover is a fast-acting cleaning agent that effectively removes a number of tough stains and reisudes from stone flooring.
Effect against:
- Cement residues
- Limescae
- Grout stain
- Efflorescence
- Other
This grout stain remover meets each challenge with the simple change of its level of dilution. LTP Grout Stain Remover can be used successfully both on indoor surfaces and outdoor stone flooring.
LTP Grout Stain Remover may be used in dilute or concentrated form. Not suitable for use on surfaces that are calcareous, sensitive to acids or contain lime.
LTP Grout Stain Remover Suitable for Use On:
- Glazed and Unglazed Ceramics
- Slate
- Quarry Tiles
- Brick
- Terracotta
- Acid Resistant Natural Stones
LTP Grout Stain Remover Coverage and Dilution Guide (1 Litre):
- Mild: 1:4 ratio covers approx 25 squared metres
- Severe: 1:1 ratio covers approx 10 squared metres
- Extreme: undiluted covers approx 5 squared metres
LTP Grout Stain Remover Method of Use:
- Dilute down to a ratio of between 1:1 and 1:4, or undiluted in extreme cases
- Apply the diluted LTP Grout Stain Remover a few square meters at a time
- Leave for 10-20 minutes depending on the surface
- Add a little water and then scrub stone surface to release any residues or stains
- Sponge up released residues, rinse with water a second time and sponge again
- Allow surfaces to dry before allowing traffic or sealing
- For general use apply with a mop or cloth
- Wipe off thoroughly with a clean damp cloth once applied
- For more severe cases, agitate with a scrubbing brush if necessary
- Leave to react for 5-10 minutes. Rinse with clean water once reacted
- For more extreme cases use undiluted and agitate with a scrubbing brush
- Neutralise the surface with clean water after use
LTP Grout Stain Remover Additional Information:
- It is important to test the solution on an inconspicuous area before general application
- Do not use it when underfloor heating systems are in operation
- Prolonged contact with grout joints should be avoided
- In conditions of extreme humidity LTP Grout Stain Remover vapour may react with acid-sensitive surfaces.
The LTP Grout Stain Remover is available through Tiling Logistics, the natural stone renovation specialists based in Birmingham. We strive for a same-day dispatch service and free delivery is available on orders over £75.