Faber Oil & Grease Remover for Stone Floor and Tiles

Faber Oil & Grease Remover is specifically formulated to extract and remove stains from spilled oily substances, including cooking oil, greasy food residues, engine oil, mineral oil, diesel fuel, fuels, and lubricants. Faber Oil & Grease Remover is applied straight onto the stain to be extracted without having to work on it further

Faber Oil & Grease Remover increases the extractive effectiveness, making it possible for it to remove deep, older and stubborn stains. Faber Oil & Grease Remover is effective on stains from tarry residues. Faber Oil & Grease Remover is easy to use on vertical surfaces, thanks to its thick, viscosity consistency

Faber Oil & Grease Remover’s action will not ruin the surface and can even be used on sensitive materials, such as marble and more delicate natural stone

Suitable For Use On:
- Marble/ Marble Agglomerates
- Quartz-resin Agglomerate
- Slate
- Sandstone
- Basaltina - Lava Stone
- Molten Basalt
- Cementina
- Concrete
- Craquelé/ Glazed Ceramics
- Clinker
- Cotto
- Granite
- All Porcelain Stoneware
- Cement Grout
- Limestone
- Exposed Brick
- Reconstituted Eco Stone
- Porphyry
- Quartzite
- Terracotta
- Travertine
- Tuff

Coverage:
- N/A

Method Of Use:
- Thoroughly rinse the surface with clean water and allow it to dry
- Apply a thick, even layer of undiluted Faber Oil & Grease Remover straight onto the surface being treated, using a brush or spatula
- Leave to act on the surface until the synthetic layer has broken completely, following the necessary times:
- Non-absorbent surfaces or light residues: leave for 10-20 minutes
- Absorbent surfaces or stubborn residues: leave for 1-4 hours
- Particularly stubborn residues: leave for 12-24 hours
- Proceed to remove the product and its residues, using absorbent paper or cloths
- Wipe the surface with a slightly damp cloth or mop, depending on the size of the surface, and wait for it to dry thoroughly before assessing the stain removal results

Additional Information:
- Never apply Faber Oil & Grease Remover to wet or heated surfaces
- Any adjacent surfaces not being treated with Faber Oil & Grease Remover must be protected
- It is important to test the solution on an inconspicuous area before general application
- Surfaces must be between 5 and 40°C before application

The Faber Oil & Grease Remover is available through Tiling Logistics, the natural stone renovation specialists based in Birmingham. We strive for a same-day dispatch service and free delivery is available on orders over £75.