Faber Professional Hidro SST Deep Impregnator Rising Damp Protection

Faber Hidro SST is a top-quality impregnating treatment to protect the natural stone against the harmful effects of water and rising dampness. Faber Hidro SST penetrates natural stone deep down, ensuring strong, lasting protection without compromising the original breathability of the surface, whilst not altering the original appearance of the material

Faber Hidro SST is a product that combines water-repellent properties with good resistance to rising dampness, which is responsible for the majority of problems generally found on natural stone. Faber Hidro SST 's unique selling point is that it helps to increase the resistance of the natural material to dirt and foot traffic, working as a definitive solution due to its high resistance to the action of dewaxed

Faber Hidro SST is particularly recommended for pre-installation treatment on natural surfaces. Faber Hidro SST is also certified for contact with foods

Suitable for Use On:
- Marble/ Marble Agglomerates
- Granite
- Limestone
- Sandstone
- Slate
- Basaltina
- Quartzite
- Travertine

Coverage Guide (1 Litre):
- Approximately 10 to 15 square metres, depending on the determined suitability for the surface

Method of Use:
- Dilute down to a ratio of between 1:1 and 1:4, or undiluted in extreme cases
- Clean away any surface residues before proceeding to wash the surface
- Thoroughly rinse with clean water and allow it to dry
- Apply a layer of Faber Hidro SST in even coats that cover the whole surface, including both the top and edges of the slab/tile, using a clean brush or roller
- After about 5-10 minutes, before the product dries, even out any product residues remaining on the surface, taking care to distribute them uniformly
- For a perfectly clean surface in this stage, we recommend redistributing residues until they have been completely eliminated
- Leave to dry for 1-2 hours, reposition the slabs or tiles in order to be able to treat the bottom proceeding as described above
- Remove the redistributed residues once the material is completely dry using a white pad or a damp cloth

Additional Information:
- Wait 24 hours before laying the newly treated slab
- Any adjacent surfaces not being treated with Faber Hidro SST must be protected
- It is important to test the solution on an inconspicuous area before general application
- Surfaces must be between 5 and 40°C before application

The Faber Hidro SST is available through Tiling Logistics, the natural stone renovation specialists based in Birmingham. We strive for a same-day dispatch service and free delivery is available on orders over £75.