Facebook Pixel
Faber Tile Cleaner
Faber Tile Cleaner Faber Tile Cleaner
Faber

Faber Showroom Tile Cleaner Deep Cleaning Detergent for Tiles 1L

£20.05 £16.71
More Information
EAN 8027365010330
Size Litre 1L
Downloads

- Top-Level Cleaning Action
- Dissolves And Removes Dirt
- Gentle On Materials And Grout Widths
- Interior & Exterior Use
- Effective On Grout Residues, Cement, and Epoxy Based

Full Description

Faber Tile Cleaner is a slightly acidic, water-based detergent for deep cleaning of different surfaces. Faber Tile Cleaner, when used undiluted, serves to remove surface patinas from incorrect routine maintenance carried out using unsuitable cleaners and it is also active on patinas caused by grout and seals, whether cement or epoxy-based. Faber Tile Cleaner is recommended for use on all materials that are not acid sensitive

Faber Tile Cleaner’s special formula allows it to penetrate inside the pores and texture deep down. Faber Tile Cleaner is able to dissolve and remove the dirt that has built upon the material, even in cases of old, stubborn residues to restore the original appearance of the material

Suitable For Use On:
- Slate
- Sandstone
- Basaltina - Lava Stone
- Molten Basalt
- Glazed Ceramics
- Clinker
- Cotto
- Granite
- All Porcelain Stoneware
- Reconstituted Eco Stone
- Porphyry
- Quartzite
- Terracotta
- Tuff

Coverage and Dilution Guide:
- Dilute Faber Tile Cleaner with clean water
- Use in a 1:3 ratio
- For more stubborn residues use in a 1:2 ratio
- For extreme stubborn residues use undiluted
- Approximately 10-15 square metres, depending on the determined suitability for the surface

Method of Use:
- Dilute down to a ratio of between 1:2 and 1:3, or undiluted in extreme cases
- Thoroughly rinse the surface with clean water and allow it to dry
- Apply Faber Tile Cleaner, rubbing it into the surface with a brush, mop or single-disc machines
- Leave for 10-20 minutes, continuing to wipe over the surface with the tool of choice
- Remove all residues and rinse the whole floor with plenty of clean water, no further action or waiting time is necessary
- If needed, repeat the application process following the same steps and increase the concentration

Additional Information:
- Never apply Faber Tile Cleaner to wet or damp surfaces
- Any adjacent surfaces not being treated with Faber Tile Cleaner must be protected
- It is important to test the solution on an inconspicuous area before general application
- Surfaces must be between 5 and 40°C before application

The Faber Tile Cleaner is available through Tiling Logistics, the natural stone renovation specialists based in Birmingham. We strive for a same-day dispatch service and free delivery is available on orders over £75.

Write Your Own Review
You're reviewing:Faber Showroom Tile Cleaner Deep Cleaning Detergent for Tiles 1L
Your Rating
Trustpilot