Facebook Pixel
Faber Deterfug Deep Acidic Detergent for Cleaning on Different Surfaces
Faber Deterfug Deep Acidic Detergent for Cleaning on Different Surfaces
Faber Surface Care

Faber Deterfug Slightly Acidic Detergent for Deep Down Cleaning

SALE From £10.38 £8.65 RRP £11.94
SALE From £10.38 £8.65 RRP £11.94
More Information
Downloads

- Guaranteed Deep Cleaner
- Excellent Cleaning Power 
- Extremely Effective On Dirt Of Different Types
- Interior & Exterior Use
- Dilute with water to a ratio of between 1:2 and 1:9

Full Description

Faber Deterfug is a slightly acidic cleaner for different surfaces and is specially formulated and developed to clean deep down and remove stubborn dirt from surfaces. Faber Deterfug has a deep cleaning action, even acting within the pores and rough surfaces of materials for fast, complete removal of built-up dirt, without damaging the surface

Faber Deterfug is active against different types of dirt, including oily or inorganic, and this means it is also ideal for extraordinary surface cleaning operations. When it is used regularly, it can dissolve and remove dirt that has built up and which daily cleaners cannot shift. Faber Deterfug can be successfully used on unpolished limestone surfaces, combining the efficient scale-removing action of an acid-based product with the gentle action of its special formula

Faber Deterfug is very effective when it comes to removing the surface film that can be found on many floors due to insufficiently thorough worksite cleaning or when epoxy or cement-based fillers have been used, or even due to insufficient maintenance or deposits from other detergents. Faber Deterfug also completely renews grout, removing the build-up of dirt and restoring its original appearance

Suitable For Use On:
- Marble-Quartz Agglomerate
- Slate
- Sandstone
- Concrete
- Glazed Ceramics
- Granite
- Porcelain Stoneware
- Reconstituted Eco Stone
- Porphyry
- Quartzite
- Terracotta
- Tuff

Not suitable for use on polished lime-based materials (marble, travertine, limestone, marble-cement agglomerate, marble-resin agglomerate)

Coverage and Dilution Guide (1 Litre):
- Approximately 10 to 15 square metres, depending on the determined suitability for the surface
- Surface Film Removal: Undiluted
- Extraordinary Cleaning: 1:2
- Simple Cleaning: 1:9

Method of Use:
- Dilute down to a ratio of between 1:2 and 1:9, or undiluted in extreme cases
- Clean the surface, making sure to remove any dust or dirt present, using a broom or vacuum cleaner
- Apply Faber Deterfug to the surface, in small areas at a time, distributing it evenly with a large brush or single-disc machine
- Leave for 10-15 minutes, helping its dissolving action by passing over with a large brush or single-disc machine
- Remove the cleaning residues, following the guide's time, using clean water onto the surface distributed evenly
- Remove any excess liquid which can be absorbed with cloths, absorbent paper towels or a  liquid vacuum cleaner
- Rinse the surface thoroughly using clean water
- Repeat the operation if needed

Additional Information:
- Always keep a fine layer of product throughout the treatment, even if more is needed to be added
- Any adjacent surfaces not being treated with Faber Deterfug must be protected
- It is important to test the solution on an inconspicuous area before general application

The Faber Deterfug is available through Tiling Logistics, the natural stone renovation specialists based in Birmingham. We strive for a same-day dispatch service and free delivery is available on orders over £75.

Write Your Own Review
You're reviewing:Faber Deterfug Slightly Acidic Detergent for Deep Down Cleaning
Your Rating
Trustpilot